B-body Dash Screws, Nuts, Shroud, Hardware
(1968, 1969, 1970 Plymouth GTX, Road Runner, Satellite and Dodge Charger, Coronet, Super Bee)
DASH FRAME HARDWARE
● Special screws to attach radio bezel or A/C vent covers to dash frame:
1968-69 uses (3) screws; 1970 uses (4) screws
● Special screws (5) to attach 1968-70 rallye (and 1967-71 Dart standard) cluster housing to dash frame. Fillister head, black.
● Special hardware for 1968-70 B-body Standard with
optional glove box and driver side plastic upper bezels:
The 1968 and 1969 thick, clear/black/silver woodgrain
bezels are extremely fragile in the area where this
hardware attaches them to the dash frame. A screw
bonded to a tiny plate, with a nut and plastic insert allows
tightening the bezel just snug, without cracking it. One of
these hardware assemblies is used on the driver side
bezel, and one on the glove box bezel. Some 1970
B-body standard black/woodgrain bezels may use
either one or two of these screws.
A/C and HEATER HARDWARE
● 1968 Heater Control Push-On Nuts (4)
● 1968-70 Cardboard Shroud for A/C Control Light Bar
● 1968-70 Vent Slat Rods: To keep center double vent
slats aligned in the same direction. Only straight rods
are available, no offset rods. Also fits some E-body A/C
vents.
● 1969-70 Heater Control Push-On Nuts (7): For faceplate and buttons (needed if you completely disassemble the heater controls)